Currysmarter Curtain Control MQTT frequency

[Bilal]

Hi.

I have the Curtain Control Model from Currysmarter. Everything works great but I noticed that it's sending a lot of MQTT messages to the result topic. A few times every second.

Code: Select all

11/14/2024 12:31:46 AM(-0.03 seconds)
{"If":"Done"}
11/14/2024 12:31:45 AM(-0.45 seconds)
{"Var3":"20"}
11/14/2024 12:31:45 AM(-0.03 seconds)
{"If":"Done"}
11/14/2024 12:31:45 AM(-0.56 seconds)
{"Var4":"19"}
11/14/2024 12:31:45 AM(-0.02 seconds)
{"If":"Done"}
11/14/2024 12:31:44 AM(-0.37 seconds)
{"Var3":"20"}
11/14/2024 12:31:44 AM(-0.01 seconds)
{"If":"Done"}
11/14/2024 12:31:44 AM(-0.66 seconds)
{"Var4":"19"}
11/14/2024 12:31:44 AM(-0.02 seconds)
{"If":"Done"}
11/14/2024 12:31:43 AM(-0.32 seconds)
{"Var3":"20"}
11/14/2024 12:31:43 AM(-0.01 seconds)
{"If":"Done"}

Is it possible to decrease that?
I updated to Tasmota32 14.3.0

[Lynn]

Sorry for the late response.
The wifi module checks the position of the shutter all the time. In case it is manually up/down, the device will report to MQTT immediately.
Just like some sensor switches, and power monitoring switches.
You can also use command "TelePeriod x" to adjust the frequency.
Please refer the post:
viewtopic.php?t=15&sid=87f55d5ca588c98ccfda5f6c85b388d7