MY TASMOTA

Firmware Download/Upgrade Link
firmware/EU-CL02_esp32c3.bin

Hi,
Could you provide an updated version of the firmware, I have mqtt+tls (letsecnrypt based) and it couldn't connect to tls-enabled mqtt.
Regards

I was also looking for an newer firmware.
I used update with:
http://ota.tasmota.com/tasmota32/releas ... ta32c3.bin
Because the shutter device currysmarter with tasmota came with:
firmware/EU-CL02_esp32c3.bin

This version wasn't able to update to the newer firmware.
Now I am not sure, which functions of the device were now destroyed???

I have Problems with timmer in the WEBUI of this Tasmota switches from currysmarter.
I read the post of using Home assistant! I don't understand, what is the meaning there!?
Never used Homeassistant before!
????
Why it isn't possible tu use the timeschedule in the webui.
But I know today, it isn't working rigtht.
???

When will the firmware be updated?
Where can you find the basics of realising rules and so on!

How can the timers be used in the WEBUI?

Is Homeassistant a solution for all questions here?


Where can I find more information?

So far I've only used the WEBUI Tasmota and I didn't want to set up a Home Assistant, although I still have a Raspberry lying around.

I can't manage to use the timers as usual in WEBUI!
I have a switch from NOUS, there is a switch 1 for "Open" and a switch 2 for "Close".
There it is easy to set the timers for switch 1 and 2 in WEBUI and the opening and closing works perfectly after the timers.

How does this work with the 14 CurrySmarter switches with TASMOTA?
I have tried many settings and have not achieved my goal!

There is only one output 1 in the timer, which I can assign with "Off / On / Toggle or Rule".
But now it happens, no matter what I set, with one timer the switch opens the roller shutter for example, with the next switching point the timer closes the roller shutter again in the time sequence. Even this does not work reliably!
The problem also is, If you set two timers per day, one for "open" and one for "close", the switch will only make the usual function out of it, in addition to what was there before.
So if it works to open the roller shutter with a timer and another one should take over the closing in the evening, then it is enough that someone operates the roller shutter manually and then the roller shutter opens or closes with the next timer! That's bad and unreliable!

Example: My wife stops the kitchen shutters in the morning when they open in the morning at a point as far as she wants the shutters open.
Percentage setting of the shutters ???
If the closing timer is then to work in the evening, the shutters may open or close. Or they work in opposite directions, one opens the other closes ???

Is it possible to visualise the RULES with which the switches are equipped?

I don't know how to evaluate the Rule function in the timers because I don't know how this is supposed to work!

Is it possible to automate the switches so that they open and close according to a schedule?

All other questions later!

Best regards Mirko